Dating ford emblems Chat webcam online hot woman fuck porn irane free

06-Nov-2016 18:38

I used a air hammer with a chisel knocked the heads off the rivets on the outside of the frame, then used a punch bit to knock them out, the only problem I ran into was with the bottom two rivets on each side they have a plate on the inside of the frame, you will need to chisel off that head also then punch them out.

( A torch might of worked better.) Then just bolt the hangers right up to the original holes.

Put the tie rod extender on the spindle, (you do not have to tighten it up yet.) Then when you are going back on with the coil spring get your tie rod started in the tie rod extender.

(Hit the spindle where the tie rod goes through it to knock out the tie rods.) Now the coil spring, you will need a open end wrench to take the nut off inside the spring.In my spare time I would work on my truck in my parents carport.The first thing I had to do when I got the truck was put a sound system in it.You will need to notch the bottom of the bed for clearance, where you took off that arm.(I have a picture.) The hangers were straight froward.

(Hit the spindle where the tie rod goes through it to knock out the tie rods.) Now the coil spring, you will need a open end wrench to take the nut off inside the spring.In my spare time I would work on my truck in my parents carport.The first thing I had to do when I got the truck was put a sound system in it.You will need to notch the bottom of the bed for clearance, where you took off that arm.(I have a picture.) The hangers were straight froward.USDA’s Farm Service Agency has offices in nearly every county in the country.